Changing The Value Of An Sp Mode - Ricoh FT5535 Service Manual

How to select the program number
Program numbers are composed of two or three levels.
––
1st Level
Program Number
To input the required program number, select each program level in
sequence.
1. Select the 1st level and 2nd level program numbers at the numeric keys.
Then press the
2. If there are third level programs in this SP mode: Select the 3rd level
program number by pressing the
level program number is displayed in the copy counter. Then press the
key.
If there are no third level programs in this SP mode: Do not press the
,
Note: If you need to return to one level before, press the
3. Input the required setting as explained in the following section.

2.1.2 Changing the Value of an SP Mode

1. Enter the SP mode.
2. Select the required program mode as explained above.
3. The current setting will be displayed in the reduce/enlarge indicator.
4. Enter the required setting using the numeric keys, then press the
key. (SP mode numbers and their possible settings are given in
the SP mode table.)
5. Leave SP mode.
A156/A160/A162
CÓPIA NÃO CONTROLADA
––
2nd Level 3rd Level
Program Number Program Number
key.
, or keys at this time.
4-8
CÓPIA NÃO CONTROLADA
and keys. The 3rd
key.
FSM