Chapter 39: Dhcp Commands; Dhcp Client; Ip Dhcp Client-Identifier; Table 39-1 Dhcp Commands - SMC Networks TigerStack II SMC8926EM Management Manual

Chapter 39: DHCP Commands

These commands are used to configure Dynamic Host Configuration Protocol
(DHCP) client, relay, and server functions. You can configure any VLAN interface to
be automatically assigned an IP address via DHCP. This switch can be configured to
relay DHCP client configuration requests to a DHCP server on another network, or
you can configure this switch to provide DHCP service directly to any client.
Command Group

DHCP Client

DHCP Relay
DHCP Server
DHCP Client
Use the commands in this section to allow the switch's VLAN interfaces to
dynamically acquire IP address information.
Command

ip dhcp client-identifier

ip dhcp restart client
ip dhcp client-identifier
This command specifies the DCHP client identifier for the current interface. Use the
no form to remove this identifier.
Syntax
ip dhcp client-identifier {text text | hex hex}
no ip dhcp client-identifier
• text - A text string. (Range: 1-15 characters)
• hex - The hexadecimal value.
Default Setting
None
Command Mode
Interface Configuration (VLAN)

Table 39-1 DHCP Commands

Function
Allows interfaces to dynamically acquire IP address information
Relays DHCP requests from local hosts to a remote DHCP server
Configures DHCP service using address pools or static bindings

Table 39-2 DHCP Client Commands

Function
Specifies the DHCP client identifier for this switch
Submits a BOOTP or DHCP client request
Page
39-1
39-3
39-5
Mode Page
IC 39-1
PE 39-2
39-1