Dhcp Commands - SMC Networks TigerStack II SMC8848M Management Manual

These commands are used to configure Dynamic Host Configuration
Protocol (DHCP) client, relay, and server functions. You can configure any
VLAN interface to be automatically assigned an IP address via DHCP.
This switch can be configured to relay DHCP client configuration requests
to a DHCP server on another network, or you can configure this switch to
provide DHCP service directly to any client.
Command Group
DHCP Client
DHCP Relay
DHCP Server
DHCP C
Table 35-1 DHCP Commands
Function
Allows interfaces to dynamically acquire IP address
information
Relays DHCP requests from local hosts to a remote
DHCP server
Configures DHCP service using address pools or
static bindings
C
HAPTER
OMMANDS
35
Page
35-2
35-4
35-6
35-1