Default Setting Configurations
3
Selecting Setup Mode
Press and hold SET key and power- on the instrument from OFF status.
Release SET key when you hear a beep, the instrument will then enter
setup mode. These parameters will be remained in the non- volatile
memory even after the instrument is turned off. To configure the related
parameters on setup mode, ensure that the following procedures are
followed:
1 Press
(Left) or
(Right) key to select which menu item to be set.
2 Press
(Up) or
(Down) key to change the parameter.
3 Press SET key to select the digit to be adjusted, the selected digit will
flash.
4 Press and hold SAVE key for more than 1 s to save your setting.
5 Press SET key for more than 1 s to exit setup mode.
U1701B User's and Service Guide
33