Warning Message And Troubleshooting - Epson AcuLaser C9200N Service Manual

EPSON AcuLaser C9200N

1.2.2 Warning Message and Troubleshooting

Table 1-8. Warning Message and Troubleshooting
Message Explanation
An attempt has been made to
register a new Re-Print Job, Verify
Job, Stored Job or Confidential Job
though the number of registrations
has reached the maximum.
When the user attempted to register
a Re-Print Job or Verify Job, there
was already a Stored Job registered
by same user name or job name.
Reserve Job Canceled
Insufficient capacity of RAM disk.
Or, RAM Disk is set to Off.
Insufficient capacity of
CompactFlash. Or, a
CompactFlash is not installed.
The CompactFlash memory is full
CompactFlash Full and collated print jobs, form data,
reserve jobs etc. cannot be saved.
The user attempted registration
after reaching the maximum
number.
The USB memory is not installed,
Form Data Canceled
or was removed while registering.
Or, the capacity of the USB
memory is insufficient.
A CompactFlash is not installed.
When downloading PS3 fonts, the
PS3CompactFlash Full CompactFlash memory is full and
the fonts cannot be saved.
PRODUCT DESCRIPTION
Remedy
Delete or print the registered
Re-Print Jobs, Verify Jobs,
Stored Jobs or Confidential
Jobs.
When there is another Stored
Job with the same user name or
Can't Print
job name, either change the job
name and register it or delete
the Stored Job.
Set RAM Disk to Normal or
Maximum if RAM Disk is set
to Off. Increase the RAM Disk
capacity or add more RAM if
RAM Disk is already set to
Normal or Maximum.
Check Paper Size
Install a CompactFlash if a
CompactFlash is not installed.
Delete unnecessary form data
and Reserve Jobs (Re-Print,
Verify, Stored, and
Confidential).
Image Optimum
Delete registered forms. Or,
replace the USB memory.
Check if the USB memory is
installed. Or, replace with
another USB memory with a
larger capacity.
Install a CompactFlash.
Not Supported USB
Device xxx
Delete previously downloaded
fonts to empty the
CompactFlash memory.
List of Printer Messages
Table 1-8. Warning Message and Troubleshooting
Message Explanation
Data was disregarded and not
printed due to a problem in the
data. The following are conditions
of this warning.
Bandwidth of the received data
does not match the value
determined by the paper size.
The received data contains
undefined intermediate codes or
compression format.
Checksums attached to the
intermediate code data using
ESC/Page and ESC/Page-Color
do not match checksums of the
actual data.
Data cannot be read from the
USB memory where print data
is stored.
The paper size for the loaded paper
and specified paper do not match.
Printing with PS
This warning occurs when
memory is insufficient, and the
resolution is reduced.
Printing with the ESC/Page-
Color driver or EPSON PCL
driver
This warning occurs when data
is compressed with a higher
level of compression.
The USB device (other than a
memory device) or a USB memory
with a hub currently connected to
the USB port is not supported. A
file check is performed whenever a
new device is found on the USB
port, and this error occurs at the
point.
Revision D
Remedy
This error occurs when a
printer driver for a different
printer is used. Check the
printer and reinstall it if it is an
incorrect driver. When printing
from a USB memory, check
and reinsert the USB memory.
Set the paper of the specified
size.
Printing with PS
Add memory.
ESC/Page-Color driver or
EPSON PCL driver
Set the priority of the driver
data compression method
to quality.
Disconnect the USB memory
from the USB port, or specify
Clear Warning to clear the
warning.
28
Confidential