Rear Frame Removal - Epson ActionLaser 1600 Service Manual

Rear Frame Removal

1. Remove the video controller board (C125 MAIN board). (Refer to pages 3-7
and 3-8 .)
2. Open the top cover.
cartridge to protect it from light or place it in a dark area.
3. Remove the control panel. (Refer to page 3-10.)
4. Remove the paper cover.
5. Remove the right cover and left cover. (Refer to pages 3-11 and 3-12.)
6. Remove the top cover.
7. Remove 6 CP(0) (M3 x 6) screws and lift the rear frame.
8. Disconnect connector CN1 on the power supply board (PWB-E) and connector
CN2 on the high-voltage supply board (PWB-F).
EPSON ActionLaser 1600 Service Manual
Remove the imaging cartridge. Cover the imaging
Figure 3-9. Removing the Rear Frame
Disassembly and Assembly
3-13