SC-F2000
3.1.4 Recommended Tools
To protect this product from damage, use the tools indicated in the following table. For
the tools required to perform the adjustment, refer to "Tools/Consumables for
Adjustments" in Chapter 4.
Table 3-1. Tools
Name
Description
4 cm or longer shaft length (The
Phillips screwdriver, No. 1
one with a magnet is
recommended)
40 cm or longer shaft length (The
Phillips screwdriver, No. 2
one with a magnet is
recommended)
Hexagon screwdriver
Nothing in particular
(5 mm)
Stubby screwdriver
Nothing in particular
Tweezers
Nothing in particular
To secure the cable/harness, or for
Acetate tape
the protection against the sharp
edge
To prevent staining the printer
Waste cloth
with ink during operation
DISASSEMBLY & ASSEMBLY
Target Part
PRINT HEAD
Some encoders/sensors
Parts in general
PG SWITCH LEVER ASSY
POWER SUPPLY BOARD
Parts in general
Parts in general (Use this tape
when it is removed or when
replacing the part)
TUBE ASSY
LEFT INK HOLDER
ASSY / RIGHT INK
HOLDER ASSY
DUMPER KIT
PRINT HEAD
PUMP CAP ASSY
BUFFR ASSY
CIRCULATION PUMP
ASSY
Overview
Revision C
56
Confidential