Canon imagePRESS C1 P Service Manual page 1132

Subheading
LDAP-DEF Switch the default setting of the LDAP searching condition.
Change the default setting of a searching attribute condition specified for LDAP searching.
Setting range
0 to 6
0: "Name"
1: "E-mail"
2: "FAX"
3: "Organization"
4: "Unit of organization"
5: User setting 1
6: User setting 2
Standard value
0
Refer to COPIER > OPTION> USER > LDAP-SW for the details of LDAP.
DK3-ASST Switch the air heater control for the pickup deck with air-assist function. (Setting for PDO deck
Lite)
Switch the condition to turn on the air heater for air-assist function according to the media and
environment.
Setting range
0: Control the air heater based on the media and environment condition.
1: Turn on the air heater based on the environment condition only. (Not dependent on the media)
2: Turn on the air heater constantly. (Not dependent on the environment and media)
Standard value
0
Remarks
When switching the media setting from non-coated paper to coated paper for the pickup deck with
air-assist function, wait-time occurs before the temperature of the air heater is controlled. (For
coated paper, pickup cannot be performed until the air heater is turned on and warm air blows.)
Furthermore, when the machine is used in the environment near the ON/OFF switching condition,
it is assumed that the ON/OFF switching of the air heater is frequently performed and it increases
the wait-time.
When you receive a claim from a user that the wait-time is too long, perform the following
measures;
- For the former case (switching of the media setting from non-coated paper to coated paper),
explain that transfer performance of no
FX-BC-SW
Set ON/OFF of the wait-mode control for cooling of the fixing assembly.
Setting range
OFF [0] / ON [1]
Standard value
0
CARD-DIR 4-pane postcard feeding direction setting
Set the feeding direction of 4-pane postcard.
Setting range: 0 to 1
0: Short edge feed only
1: Available to switch Long edge feed/Short edge feed.
Standard value 0
This item applies to the upgraded device or later (DCON Ver11.03 or later, Cont Ver24.04 or
later)
DATE-DSP
Switch the date display.
Setting range:
0: YYMM/DD
1: DD/MM'YY
2: MM/DD/YY
COPIER>OPTION>USER
Contents
Chapter 16
Level
1
1
1
1
2
16-235