Canon imagePRESS C1 P Service Manual page 1140

Subheading
COIN
DK-P
CARD-SW
SC-TYPE
CC-SPSW
5. INT-FACE
Subheading
IMG-CONT
When the value is set to 1, the values of the following user mode items return to the standard values of EFI.
- System administration setting > Network setting > TCP/IP setting > IP address setting > IP address
- System administration setting > Network setting > TCP/IP setting > IP address setting > Subnet mask
- System administration setting > Network setting > TCP/IP setting > IP address setting > Gateway address
- System administration setting > Network setting > TCP/IP setting > Ethernet driver setting > Communication method
- System administration setting > Network setting > TCP/IP setting > Ethernet driver setting > Ethernet type
- System administration setting > Network setting > TCP/IP setting > Activation time
Switch a coin vendor.
Set whether or not to enter an administrator's mode of a coin vendor.
Setting range
0: Coin vendor unavailable (Control card is available. No charging)
1: Coin vendor (with charging)
2: Distant-place counter (with charging)
Standard value
0
Set a paper size to be used for the paper deck (option).
Setting range
0 to 2
0: A4, 1: B5, 2: LTR
Standard value
0
Switch the UI screen for a coin vendor.
Setting range
0: Coin
1: Card
2: Coin and card
Standard value
0
Switching-over of the type of the Self Copier type machine (coin vender-capable machine)
Available only when the Soft ID for the machine is set as a specific user. This service mode is
used to switch over the machine type to a specific user type machine or generic Self Copier type
machine. Generic Self Copier has more functions than the specific user type machine.
Setting range
0: Specific user type machine
1: Generic Self Copier type machine
Standard value
0
Switch the I/F support level of the control card (CCIV/CCV).
Setting range
0: Do not support the card.
1: Support the card. (Prioritize the speed.)
2: Support the card. (Prioritize the upper limit number of copies.)
Standard value
0
- When this mode is set to 1, the maintenance of engine performance is prioritized, and the
operation cannot be stopped accurately based on the upper limit number of copies.
- When this mode is set to 2, the operation can be stopped accurately based on the upper limit
number of copies, but engine performance may be decreased for a certain cassette.
COPIER>OPTION>INT-FACE
Connecting Setting of External PDL Controller
Setting range
0: Normal operation
1: Not used
2: Not used
3: EFI controller
4: Not used
5: Not used
Standard value
0
T-16-191
COPIER>OPTION>ACC
Contents
T-16-192
Contents
Chapter 16
Level
1
1
1
2
2
Level
1
16-243