Go through the following to format the HDD for BOOTDEV partition:
1) If the machine is on, go through the shut-down instructions appearing on the control panel screen so that the main power switch may be turned off. (The main
power will go off automatically.)
2) Connect the USB device to the USB port.
3) Start up the machine in safe mode.
4) Follow the instructions on the control panel, and press the appropriate key.
[4] -> [0]: go to Partition Selection screen / other that [0]: go back to Menu screen
5) Go through the instructions on the control panel, and press the appropriate key.
[1] -> [0]: execute BOOTDEV formatting / other than [0]: go back to Menu screen
[C]: go back to Menu screen
6) At the end of formatting, a message will appear asking you to press a key. Press any key to go back to the Men screen.
7) Start downloading the system software. For instructions, see "Downloading the System Software."
17.6.7 Other Functions
imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+
[5]: Backup
This function is for R&D purposes only. Do not use it.
[6]: Restore former version (in the presence of backup of system software)
Use it to restore the backup of the system software while saving the system software that is current as a backup.
<Procedure>
1) If the machine is on, go through the shut-down instructions appearing on the control panel screen so that the main power switch may be turned off. (The main
power will go off automatically.)
2) Connect the USB device to the USB port.
3) Put the machine in download mode (normal or safe).
4) Go through the instructions on the control panel, and press the appropriate key.
F-17-60
F-17-61
F-17-62
Chapter 17
0013-8305
17-29