Formatting The Hdd - Canon imagePRESS C1 P Service Manual

Chapter 17
[3]: Upgrade (Overwrite all)
The system software in the USB device will overwrite the software on the HDD regardless of the version of the latter. Unlike menu item [1], however, the
machine will not restart on its own at the end of downloading. When the power is turned off and then back on manually, the machine starts writing the system
software.
<Procedure>
1) If the machine is on, go through the shut-down instructions appearing on the control panel screen so that the main power switch may be turned off. (The main
power will go off automatically.)
2) Connect the USB device to the USB port.
3) Put the machine in download mode (normal or safe).
4) Go through the instructions on the control panel, and press the appropriate key.
[3] -> [0]: execute download / other that [0]: go back to Menu screen
5) While downloading is under way, the control panel screen shows its progress. At the end of downloading, a message will appear asking you to press a key. Press
the appropriate key. If the machine is in normal mode, the shut-down sequence will start.
6) When a message appears asking you to turn off the power, turn off the main power, remove the USB device, and turn the main power switch back on.
7) Upon start-up, the machine starts writing the system software to the system area of the HDD or the flash ROM. At the end of writing, a message will appear
asking you to turn off and then back on the power. Turn off and then on the main switch.

17.6.6 Formatting the HDD

imagePRESS C1 P / imagePRESS C1 / imagePRESS C1+ (Printer) / imagePRESS C1+
This function is available only when the machine is in safe mode.
[4]: Format HDD (in the presence of BOOTDEV)
Use it to format the HDD for BOOTDEV partition.
[4]: Format HDD (ALL) (in the absence of BOOTDEV, as when replacing with new HDD)
Use it to format the HDD for full partition.
<Procedure>
17-28
F-17-57
F-17-58
F-17-59
0013-8304