Canon imagePRESS C1 P Service Manual page 1153

Chapter 16
Subheading
SMTPTXPN
SMTPRXPN
POP3PN
ORG-LGL
ORG-LTR
UI-COPY
UI-BOX
UI-SEND
UI-FAX
TMC-SLCT
DEVL-VTH
FTPTXPN
PRN-FLG
16-256
COPIER > OPTION > BODY
Change the port number for SMTP transmission.
Setting range: 0 to 65535 (incremented by 1)
Standard value: 25
Change the port number of SMTP reception.
Setting range: 0 to 65535 (incremented by 1)
Standard value: 25
Change the port number of POP reception.
Setting range: 0 to 65535 (incremented by 1)
Standard value: 110
Set the special paper size which cannot be recognized by DF.
Setting range
0: LEGAL-R
1: Bolivia OFFICIO-R
2: Argentina OFFICIO-R
3: Argentina LEGAL-R
4: Mexico OFFICIO-R
Standard value: 0
Set the special paper size which cannot be recognized by DF.
Setting range
0: LETTER [Factory setting value / Value after RAM clear]
1: EXECUTIVE
2: Korean government office paper
3: Argentina LETTER
4: Government LETTER
Standard value: 0
Make a setting to switch the display in the copy screen in the control panel.
Setting range
0: Hide the copy screen.
1: Do not hide the copy screen.
Standard value: 1
Restrict the box screen display in the control panel.
Setting range
0: BOX function unavailable (Unavailable for PDLtoBox)
1: BOX function available
2: BOX function available with restriction (Unavailable for LUI and RUI, but available for
PDLtoBOX)
Standard value: 1
Select 'hide' or 'not hide' of the transmission screen in the control panel.
Setting range
0: Hide
1: Do not hide
Standard value: 1
Select 'hide' or 'not hide' of the FAX screen in the control panel.
Setting range
0: Hide
1: Do not hide.
Standard value: 1
Switch the coefficient used for error diffusion.
Use this mode to increase dot stability and granularity so that pitch unevenness or course image
that occurred on an image can be made invisible.
Setting range
0: Normal
1: Low granularity / low stability
2: High granularity / high stability
Standard value: 0
Set the threshold value of image density to make a decision to perform the discharging sequence
for continuous printing of a low density image, which is performed as measures for a spot or
course image. Use of this mode must be avoided as much as possible when the machine has been
operating normally.
Setting range: 1 to 5 (Unit: %)
Standard value: 2
The setting value becomes valid after the main power switch is turned OFF/ON.
Specify a port number (FTP) of the SEND destination.
Setting range: 0 to 65535 (16 bit)
Standard value: 21
Select the image area flag. (for PDL image)
When a PDL image was not compressed to a specified compression ratio on the controller side,
image processing is performed based on the image area flag specified by this mode.
Setting range
0: High line number screen, gray offset LUT
1: Error diffusion, gray offset LUT
2: High line number screen, normal LUT
Standard value: 0
Contents Level
2
2
2
2
2
2
2
2
2
2
2
2
2