Table 3-6: Analog Output Pin Assignments - Teledyne t100 Operation Manual

Teledyne API - T100 UV Fluorescence SO
3.3.1.4. CURRENT LOOP ANALOG OUTPUTS (OPTION 41) SETUP
Servicing or handling of circuit components requires electrostatic
discharge protection (ESD), i.e. ESD grounding straps, mats and
containers. Failure to use ESD protection when working with electronic
assemblies will void the instrument warranty. Refer to the manual on
Fundamentals of ESD, PN 04786, which can be downloaded from our
website at
Manuals in the Special Manuals section.
06807F DCN7335
Analyzer
2

Table 3-6: Analog Output Pin Assignments

PIN ANALOG OUTPUT
1
2
3
4
5
(Only used if an
optional O
6
sensor is installed)
7
8
If your analyzer had this option installed at the factory, there are no further connections
to be made. The current loop option can be configured for any output range between 0
and 20 mA. Section 5.9.3.5 provides information on calibrating or adjusting these
outputs.
This section provides instructions for setting up the analog outputs for voltage and/or
current output. Figure 3-8 provides installation instructions and illustrates a sample
combination of one current output and two voltage outputs configuration.
•
For current output install the Current Loop option PCA on J19, on J21 or on J23 of
the motherboard.
•
For voltage output, install jumpers on J19, J21 and/or J23.
Following Figure 3-8 are instructions for converting current loop analog outputs to
standard 0-to-5 VDC outputs.
CAUTION – AVOID INVALIDATING WARRANTY
http://www.teledyne-api.com
VOLTAGE SIGNAL
V Out
A1
Ground
V Out
A2
Ground
A3 V Out
or CO
Ground
2 2
V Out
A4
Ground
under Help Center > Product
Getting Started
CURRENT SIGNAL
I Out +
I Out -
I Out +
I Out -
I Out +
I Out -
I Out +
I Out -
39