Figure 3-7: Analog Output Connector; Table 3-5: Analog Input Pin Assignments - Teledyne t100 Operation Manual

Getting Started
3.3.1.3. CONNECTING ANALOG OUTPUTS
38

Table 3-5: Analog Input Pin Assignments

PIN DESCRIPTION
1 Analog input # 1
2 Analog input # 2
3 Analog input # 3
4 Analog input # 4
5 Analog input # 5
6 Analog input # 6
7 Analog input # 7
8 Analog input # 8
GND Analog input Ground
1
See Section 7 for details on setting up the DAS.
The T100 is equipped with several analog output channels accessible through a
connector on the rear panel of the instrument. The standard configuration for these
outputs is mVDC. An optional current loop output is available for each (Section
3.3.1.4).
In default configuration, Channels A1 and A2 output a signal proportional to the SO
concentration of the sample gas. Either can be used for connecting the analog output
signal to a chart recorder or for interfacing with a datalogger.
Channel A3 is only used on the T100 if the optional O
Channel A4 is special. It can be set by the user (refer to Section 5.9.9) to output any
one of the parameters accessible through the <TST TST> buttons of the unit's sample
display.
To access these signals attach a strip chart recorder and/or data-logger to the appropriate
analog output connections on the rear panel of the analyzer.
Teledyne API - T100 UV Fluorescence SO
DAS
PARAMETER
AIN 1
AIN 2
AIN 3
AIN 4
AIN 5
AIN 6
AIN 7
AIN 8
N/A
ANALOG OUT
A1 A2 A3
+ - + - +

Figure 3-7: Analog Output Connector

1
or CO sensor is installed.
2 2
A4
- + -
06807F DCN7335
Analyzer
2
2