Figure 3-8: Current Loop Option Installed On The Motherboard - Teledyne t100 Operation Manual

Getting Started
40

Figure 3-8: Current Loop Option Installed on the Motherboard

C C
ONVERTING URRENT
V O
OLTAGE UTPUTS
To convert an output configured for current loop operation to the standard 0 to 5 VDC
output operation:
1. Turn off power to the analyzer.
2. If a recording device was connected to the output being modified, disconnect it.
3. Remove the top cover
•
Remove the side-panel screw fastening the top cover to the unit.
•
Lift the cover straight up.
4. Disconnect the current loop option PCA from the appropriate connector on the
motherboard (refer to Figure 3-8).
5. Each connector, J19 and J23, requires two shunts. Place one shunt on the
two left most pins and the second shunt on the two pins next to it (refer to
Figure 3-8).
6. Reattach the top case to the analyzer.
The analyzer is now ready to have a voltage-sensing, recording device attached to that
output.
Calibrate the analog output as described in Section 5.9.3
Teledyne API - T100 UV Fluorescence SO
L A O
OOP NALOG UTPUTS TO
Analyzer
2
S
TANDARD
06807F DCN7335