Figure 3-29: Zero/Span Calibration Procedure - Teledyne t100 Operation Manual

Teledyne API - T100 UV Fluorescence SO
The SPAN button now
appears during the transition
from zero to span.
You may see both buttons.
If either the ZERO or SPAN
buttons fail to appear see the
Troubleshooting section for
tips.
06807F DCN7335
Analyzer
2
Z /S C
ERO PAN ALIBRATION
To perform the zero/span calibration procedure (see Section 9 for manual and automatic
calibration procedures, including with valve options), press:
SAMPLE
< TST TST >
Toggle TST> button until ...
SAMPLE
< TST TST >
Allow zero gas to enter the sample port
SAMPLE
< TST TST >
M-P CAL STABIL= XXXX PPB
<TST TST>
M-P CAL
<TST TST>
Allow span gas to enter the sample port
at the rear of the analyzer.
SAMPLE STABIL= XXXX PPB
< TST TST >
M-P CAL STABIL= XXXX PPB
<TST TST> ZERO
M-P CAL STABIL= XXXX PPB
<TST TST> ENTR
M-P CAL STABIL= XXXX PPB
<TST TST> ENTR
Figure 3-29: Zero/Span Calibration Procedure
RANGE=500.0 PPB SO2= XXXX
CAL SETUP
STABIL= XXXX PPB SO2=XXX.X
CAL SETUP
at the rear of the analyzer.
STABIL= XXXX PPB SO2=XXX.X
CAL SETUP
SO2=XXX.X
ZERO CONC EXIT
STABIL= XXXX PPB SO2=XXX.X
ENTR CONC
SO2=XXX.X
CAL SETUP
SO2=XXX.X
SPAN CONC EXIT
SO2=XXX.X
CONC EXIT
SO2=XXX.X
CONC EXIT
Set the Display to show
the STABIL test function.
This function calculates
the stability of the SO
measurement.
Wait until STABIL
falls below 0.5 ppb.
This may take several
minutes.
Press ENTR to changes
the OFFSET & SLOPE
values for the SO
measurements.
Press EXIT to leave the
calibration unchanged and
return to the previous
menu.
EXIT
Wait until STABIL
falls below 0.5 ppb.
This may take several
minutes.
Press ENTR to changes
the OFFSET & SLOPE
values for the SO
measurements.
Press EXIT to leave the
calibration unchanged and
return to the previous
menu.
EXIT at this point
returns to the
SAMPLE menu.
Getting Started
2
2
2
73