Figure 11-1: Viewing And Clearing Warning Messages - Teledyne t100 Operation Manual

Teledyne API - T100 UV Fluorescence SO
In WARNING mode, <TST TST>
buttons replaced with TEST
button. Pressing TEST switches to
SAMPLE mode and hides warning
messages until new warning(s)
are activated.
If warning messages reappear,
the cause needs to be found. Do
not repeatedly clear warnings
without corrective action.
06807F DCN7335
Analyzer
2
The analyzer also issues a message via the serial port(s).
To view or clear a warning message press:
SAMPLE RANGE = 500.0 PPB
TEST CAL
SAMPLE RANGE = 500.0 PPB
< TST TST > CAL
SAMPLE SYSTEM RESET
< TST TST > CAL
Figure 11-1: Viewing and Clearing Warning Messages
SO2 =XXX.X
MSG CLR SETUP
SO2 =XXX.X
MSG CLR SETUP
SO2= X.XXX
MSG CLR SETUP
Troubleshooting & Service
MSG indicates that one or more
warning message are active but
hidden. Pressing MSG cycles
through warnings
In SAMPLE mode, all warning
messages are hidden, but MSG
button appears
Press CLR to clear the current
warning message.
If more than one warning is
active, the next message will
take its place.
Once the last warning has been
cleared, the analyzer returns to
SAMPLE Mode.
221