Figure 3-28: So 2 Span Gas Setting - Teledyne t100 Operation Manual

Getting Started
Only appears if either
the optional O or CO
2
sensors are installed.
The SO span concentration value
2
is automatically default to
400.0 PPB.
If this is not the the concentration of
the span gas being used, toggle
these buttons to set the correct
concentration of the SO calibration
2
gas.
72
S SO S G C
ET PAN AS
2
Set the expected SO span gas concentration. This should be 80% of the concentration
2
range for which the analyzer's analog output range is set.
SAMPLE RANGE=500.0 PPB
<TST TST> CAL
SAMPLE
CO O2
2
SAMPLE RANGE TO CAL:LOW
LOW HIGH
M-P CAL RANGE=400.0 PPB
<TST TST> ZERO SPAN
M-P CAL SO2 SPAN CONC:400.0 Conc
0 4 0
Figure 3-28:
Teledyne API - T100 UV Fluorescence SO
ONCENTRATION
SO2= XXXX
SETUP
GAS TO CAL:CO
ENTR
ENTR
SO2= XXXX
CONC
0 .0 0 ENTR EXIT
SO Span Gas Setting
2
EXIT
Only appears if either
the analyzer is set for
EXIT
DUAL range mode.
EXIT
EXIT ignores the new
setting and returns to
the previous display.
ENTR accepts the new
setting and returns to
the
CONCENTRATION
MENU.
06807F DCN7335
Analyzer
2