Maintenance Schedule; Table 10-1: T100 Preventive Maintenance Schedule - Teledyne t100 Operation Manual

Teledyne API – T100 UV Fluorescence SO
10.1.

MAINTENANCE SCHEDULE

Table 10-1 is the recommended maintenance schedule for the T100. Please note that in certain environments with high levels of
dust, humidity or pollutant levels some maintenance procedures may need to be performed more often than shown.
Table 10-1: T100 Preventive Maintenance Schedule
ITEM ACTION
Change particle
1
Particulate filter
filter
Review and
Verify test functions
evaluate
Evaluate offset
Zero/span check
and slope
Zero and span
1
Zero/span calibration
calibration
1
External zero air Exchange
scrubber (optional) chemical
1
Perform flow check Check Flow
Internal IZS
Replace
Permeation Tube
Perform pneumatic Verify Leak Annually or after repairs
leak check Tight
2
Pump diaphragm Replace
Calibrate UV Lamp Perform LAMP
Output CAL
Low-level
3
PMT sensor
hardware
hardware calibration
calibration
Clean
1
Sample chamber chamber,
optics windows and
filters
1
Critical flow orifice &
Replace
sintered filters
1
These Items are required to maintain full warranty; all other items are strongly recommended.
2
A pump rebuild kit is available from Teledyne API's Technical Support including all instructions and required parts (refer to Appendix B for part numbers).
3
Replace desiccant bags each time the inspection plate for the sensor assembly is removed.
06807F DCN7335
Analyzer
2
CAL MANUAL
FREQUENCY
CHECK SECTION
Weekly No 10.3.1
10.2;
Weekly No
Appendix C
Weekly -- 9.3, 9.6, 9.9
9.2, 9.4, 9.5,
Every 3 months --
9.7, 9.8
Every 3 months No 10.3.3
Every 6 Months No 10.3.7
Annually YES 10.3.2
Yes 10.3.6
involving pneumatics
Refer to
Annually Yes diaphragm kit
instructions
Prior to zero/span
5.9.6 &
calibration or PMT --
11.7.2.5
hardware calibration
On PMT/ preamp
changes if
Yes 11.7.2.8
0.7 < SLOPE or
SLOPE >1.3
11.7.2.2 &
As necessary Yes
11.7.2.3
As necessary Yes 10.3.4
Instrument Maintenance
DATE PERFORMED
209