Appendix A-3: Warnings And Test Functions - Teledyne t100 Operation Manual

APPENDIX A-3: Warnings and Test Functions

NAME
WSYSRES SYSTEM RESET
WDATAINIT DATA INITIALIZED
WCONFIGINIT CONFIG INITIALIZED
7
WSO2ALARM1 SO2 ALARM 1 WARN
7
WSO2ALARM2 SO2 ALARM 2 WARN
10+7
WO2ALARM1 O2 ALARM 1 WARN
10+7
WO2ALARM2 O2 ALARM 2 WARN
11+7
WCO2ALARM1 CO2 ALARM 1 WARN
11+7
WCO2ALARM2 CO2 ALARM 2 WARN
WPMT PMT DET WARNING
WUVLAMP UV LAMP WARNING
WSAMPFLOW SAMPLE FLOW WARN
WSAMPPRESS SAMPLE PRESS WARN
5
WVACPRESS VACUUM PRESS WARN
WBOXTEMP BOX TEMP WARNING
WRCELLTEMP RCELL TEMP WARNING
10
WO2CELLTEMP O2 CELL TEMP WARN
WIZSTEMP IZS TEMP WARNING
WPMTTEMP PMT TEMP WARNING
WDARKCAL DARK CAL WARNING
WHVPS HVPS WARNING
WDYNZERO CANNOT DYN ZERO
WDYNSPAN CANNOT DYN SPAN
WREARBOARD REAR BOARD NOT DET
WRELAYBOARD RELAY BOARD WARN
WFRONTPANEL FRONT PANEL WARN
WANALOGCAL ANALOG CAL WARNING
1
The name is used to request a message via the RS-232 interface, as in "T BOXTEMP".
2
Engineering software.
3
Current instrument units.
4
T100/M100E.
5
T100H/M100EH.
6
T100U/M100EU.
7
Concentration alarm option.
10
O option.
2
11
CO option.
2
A-12
Table A-2:
MESSAGE TEXT
Warnings
Warning Messages
DESCRIPTION
Instrument was power-cycled or the CPU was reset.
Data storage was erased.
Configuration storage was reset to factory configuration or
erased.
SO concentration alarm limit #1 exceeded
2
SO concentration alarm limit #2 exceeded
2
O concentration alarm limit #1 exceeded
2
O concentration alarm limit #2 exceeded
2
CO concentration alarm limit #1 exceeded
2
CO concentration alarm limit #2 exceeded
2
PMT detector outside of warning limits.
UV lamp reading outside of warning limits.
Sample flow outside of warning limits.
Sample pressure outside of warning limits
Vacuum pressure outside of warning.
Chassis temperature outside of warning limits
Reaction cell temperature outside of warning.
O sensor cell temperature outside of warning limits.
2
IZS temperature outside of warning limits.
PMT temperature outside of warning.
Dark offset above limit.
High voltage power supply output outside of warning limits.
Contact closure zero calibration failed while DYN_ZERO was set
to ON.
Contact closure span calibration failed while DYN_SPAN was set
to ON.
Rear board was not detected during power up.
Firmware is unable to communicate with the relay board.
Firmware is unable to communicate with the front panel.
The A/D or at least one D/A channel has not been calibrated.
06807F DCN7335