Table 6-9: Analog Output Current Loop Range; Table 6-10: Analog Output Pin Assignments - Teledyne 100E Instruction Manual

Model 100E Instruction Manual
The following DC current output limits apply to the current loop modules:
These are the physical limits of the current loop modules, typical
applications use 2-20 or 4-20 mA for the lower and upper limits.
Please specify desired range when ordering this option.
The default offset for all ranges is 0 mA.
Pin assignments for the output connector at the rear panel of the instrument are shown
in Table 6-10.
See Figure 3-2 for a the location of the analog output connector on the instruments rear
panel.
045150102 Rev XB1
Table 6-9: Analog Output Current Loop Range
Range Minimum Output
0-20 mA
ANALOG OUT
A1
+ - +

Table 6-10: Analog Output Pin Assignments

Pin Analog
output
1
A1
2
3
A2
4
5 A3
7
A4
8
Maximum Output
0 mA
A2 A3 A4
- + - + -
VOLTAGE CURRENT
Signal Signal
V Out I Out +
Ground I Out -
V Out I Out +
Ground I Out -
Not Used Not Used
V Out not available
Ground not available
Operating Instructions
20 mA
77