Figure 6-10: Comm - Status Flag Bit Assignment - Teledyne t100 Operation Manual

Communications Setup and Operation
I
MPORTANT
Press <CH and
CH> to move the
[ ] cursor left
and right along
the bit string.
6.6.2.7. INSTRUMENT ID
146
It is possible to assign more than one flag to the same Hessen status bit.
This allows the grouping of similar flags, such as all temperature
warnings, under the same status bit. Be careful not to assign conflicting
flags to the same bit as each status bit will be triggered if any of the
assigned flags are active.
To assign or reset the status flag bit assignments, access the COMMUNICATIONS
Menu (refer to Figure 5-13), then press:
SETUP X.X COMMUNICATIONS MENU
ID INET HESN COM1
Repeat pressing SET> until ...
SETUP X. HESSEN STATUS FLAGS
<SET SET> EDIT
SETUP X. PMT DET WARNING: 0002
PREV NEXT
Repeat pressing NEXT or PREV until the desired
message flag is displayed. Refer to Table 7-15.
For Example ...
SETUP X. SYSTEM RESET: 0000
PREV NEXT
SETUP X. SYSTEM RESET: [0]000
<CH CH>
Press [?]repeatedly to cycle through the available character set: 0-9
Note: Values of A-F can also be set but are meaningless.
Figure 6-10: COMM – Status Flag Bit Assignment
Each instrument on a Hessen Protocol network must have a unique identifier (ID
number). Refer to Section 5.7.1 for information and to customize the ID of each.
Teledyne API - T100 UV Fluorescence SO
I R
MPACT ON EADINGS OR
COM2 EXIT
EXIT
EDIT PRNT EXIT
EDIT PRNT EXIT
[0] ENTR EXIT
2
D
ATA
ENTR accepts the new
settings
EXIT ignores the new
settings
06807F DCN7335
Analyzer