Figure 6-7: Comm - Activating Hessen Protocol - Teledyne t100 Operation Manual

Communications Setup and Operation
6.6.2.2. ACTIVATING HESSEN PROTOCOL
Select which COMM
SETUP X.X
port to configure
ID
The sum of the mode
SETUP X.X
IDs of the selected
modes is displayed
here
SET>
SETUP X.X
Repeat the
entire process to
set up the
COM2 port
142
The first step in configuring the T100 to operate over a Hessen protocol network is to
activate the Hessen mode for COMM ports and configure the communication
parameters for the port(s) appropriately. Access the COMMUNICATIONS Menu (refer
to Figure 5-13), then press:
COMMUNICATIONS MENU
INET COM1 COM2 EXIT
COM1 MODE: 0
EDIT EXIT
COM1 QUIET MODE: OFF
NEXT OFF ENTR EXIT
Continue pressing next until ...
Figure 6-7: COMM – Activating Hessen Protocol
Teledyne API - T100 UV Fluorescence SO
SETUP X.X COM1 HESSEN PROTOCOL: OFF
PREV NEXT OFF
SETUP X.X COM1 HESSEN PROTOCOL: ON
PREV NEXT ON
SETUP X.X COM1 E,8,1 MODE: OFF
PREV NEXT OFF
SETUP X.X COM1 E,8,1 MODE: ON
PREV NEXT ON
SETUP X.X COM1 E,7,1 MODE: OFF
PREV NEXT OFF
SETUP X.X COM1 E,7,1 MODE: ON
PREV NEXT ON
Analyzer
2
ENTR EXIT
Press OFF/ON to
change
activate/deactivate
selected mode.
ENTR EXIT
ENTR EXIT
ENTR EXIT
ENTR EXIT
ENTR accepts the new
settings
EXIT ignores the new
ENTR EXIT
settings
06807F DCN7335