Setup - Pass: Password Protection; Table 5-1: Password Levels - Teledyne t100 Operation Manual

Teledyne API - T100 UV Fluorescence SO
I
MPORTANT
5.5. SETUP – PASS: PASSWORD PROTECTION

Table 5-1: Password Levels

PASSWORD
Null (000) Operation
101
Configuration/Maintenance
Configuration/Maintenance Access to Secondary SETUP Submenus VARS and DIAG whether
818
06807F DCN7335
Analyzer
2
EXAMPLE: If the reporting range limit is set for 100 ppm and the dilution ratio of
the sample gas is 20 gain, either:
•
a span gas with the concentration of 100 ppm can be used if the span gas passes
through the same dilution steps as the sample gas, or;
•
a 5 ppm span gas must be used if the span gas IS NOT routed through the
dilution system.
The analyzer multiplies the measured gas concentrations with this dilution factor and
displays the result.
Once the above settings have been entered, the instrument needs to be
recalibrated using one of the methods discussed in Section 9.
The menu system provides password protection of the calibration and setup functions to
prevent unauthorized adjustments. When the passwords have been enabled in the PASS
menu, the system will prompt the user for a password anytime a password-protected
function (e.g., SETUP) is selected. This allows normal operation of the instrument, but
requires the password (101) to access to the menus under SETUP. When PASSWORD
is disabled (SETUP>OFF), any operator can enter the Primary Setup (SETUP) and
Secondary Setup (SETUP>MORE) menus. Whether PASSWORD is enabled or
disabled, a password (default 818) is required to enter the VARS or DIAG menus in the
SETUP>MORE menu.
LEVEL
All functions of the main menu (top level (Primary) menu)
Access to Primary and Secondary SETUP Menus when PASSWORD is
enabled
PASSWORD is enabled or disabled.
I R
MPACT ON EADINGS OR
MENU ACCESS ALLOWED
SETUP Menu
D
ATA
93