Inet (Ethernet); Com1 And Com2 (Mode, Baud Rate And Test Port); Figure 5-14: Comm - Machine Id - Teledyne t100 Operation Manual

Teledyne API - T100 UV Fluorescence SO
Toggle to cycle
through the available
character set: 0-9
5.7.2.

INET (ETHERNET)

5.7.3.

COM1 AND COM2 (MODE, BAUD RATE AND TEST PORT)

06807F DCN7335
Analyzer
2
SETUP X.X COMMUNICATIONS MENU
ID INET COM1
EXIT
SETUP X. MACHINE ID: 100 ID
0 1 0
Figure 5-14:
The ID can be any 4-digit number and can also be used to identify analyzers in any
number of ways (e.g. location numbers, company asset number, etc.)
Use SETUP>COMM>INET to configure Ethernet communications, whether manually
or via DHCP. Please see Section 6.5 for configuration details.
Use the SETUP>COMM>COM1[COM2] menus to:
•
configure communication modes (Section 6.2.1)
•
view/set the baud rate (Section 6.2.2)
•
test the connections of the com ports (Section 6.2.3).
Configuring COM1 or COM2 requires setting the DCE DTE switch on the rear panel.
Section 6.1 provides DCE DTE information.
COM2
0 ENTR EXIT
COMM – Machine ID
SETUP Menu
ENTR accepts the new
settings
EXIT ignores the new
settings
99