Connecting Analog Outputs; Figure 2-6. Analog Output Connector; Table 2-4. Analog Output Pin Assignments - Teledyne T200 User Manual

CONNECTING ANALOG OUTPUTS

The rear panel Analog Output channels A1 through A4 can be mapped to reflect various
operating values in the analyzer, including concentration values, temperatures, pressures,
etc. These mappings are not configured by default and must be set by the user.
An optional Current Loop output (Section 2.3.1.4) is available for A1, A2 and A3 only.
To access these signals attach a strip chart recorder and/or data-logger to the appropriate
analog output connections on the rear panel of the analyzer.
Configure through the Setup>Analog Outputs menu (Section 2.5.8)

Table 2-4. Analog Output Pin Assignments

PIN
1
2
3
4
3
4
7
8
083730200A DCN7962
ANALOG OUT
A1 A2
+ - +

Figure 2-6. Analog Output Connector

ANALOG
SIGNAL OUT
OUTPUT
User-selected
A1
through the
Setup>Analog
Outputs menu.
A2
A3
A4
Teledyne API T200 NO/NO
A3 A4
- + - + -
STANDARD
VOLTAGE OUTPUT
V +
Ground
V +
Ground
V +
Ground
V +
Ground
/NO Analyzer with NumaView™ Software
2 x
CURRENT
LOOP OPTION
I Out +
I Out -
I Out +
I Out -
I Out +
I Out -
Not Available
Not Available
27