Table 6-7: Analog Output Voltage Range Min/Max; Table 6-9: Analog Output Pin Assignments - Teledyne 400E Instruction Manual

Model 400E Ozone Analyzer
Instruction Manual
In its standard configuration the analyzer Analog Outputs can be set for the
following DC voltage signal levels. Each range has is usable from -5% to + 5% of
the rated span voltage.
The following DC Current output options are also available from the factory:
RANGE
0-20 mA
These are the physical limits of the current loop modules, typical applications use 2-
20 or 4-20 mA for the lower and upper limits. Please specify desired range when
ordering this option.
Pin assignments for the output connector at the rear panel of the instrument are
shown in Table 6-9.
P/N 04316 Rev: B

Table 6-7: Analog Output Voltage Range Min/Max

Range Span Minimum Output
0-100 mVDC
0-1 VDC
0-5 VDC
0-10 VDC
The default offset for all ranges is 0 VDC.
Table 6-8: Analog Output Current Loop Min/Max
MINIMUM OUTPUT
+

Table 6-9: Analog Output Pin Assignments

Pin ANALOG
OUTPUT
1
A1
2
3
A2
4
5 A3
7
A4
8
Maximum Output
-5 mVDC
-0.05 VDC
-0.25 VDC
-0.5 VDC
MAXIMUM OUTPUT
0 mA
ANALOG OUT
A1 A2 A3
- + - + -
VOLTAGE CURRENT
SIGNAL
V Out
Ground
V Out
Ground
Not Used
V Out not available
Ground not available
Operating Instructions
105 mVDC
1.05 VDC
5.25 VDC
10.5 VDC
20 mA
A4
+ -
SIGNAL
I Out +
I Out -
I Out +
I Out -
Not Used
83