Figure 3-26: Reporting Range Verification - Teledyne t100 Operation Manual

Getting Started
Verify that the MODE
is set for SNGL.
If it is not, press
SINGL then ENTR
Verify that the RANGE is
set for 500.0
If it is not, toggle each
numeric button until the
proper range is set, then
press ENTR.
Verify that the UNITs
is set for PPM
If it is not, press
PPM then ENTR
70
While these are the default settings for the T100 analyzer, it is recommended that you
verify them before proceeding with the calibration procedure, by pressing:
SAMPLE
<TST TST> CAL
SETUP
CFG DAS
SETUP
MODE SET
SETUP
SNGL DUAL AUTO
SETUP
MODE SET
SETUP
0 0
SETUP
MODE SET
SETUP
PPB PPM UGM MGM
Figure 3-26:
Teledyne API - T100 UV Fluorescence SO
RANGE=500.0 PPB SO2= XXXX
PRIMARY SETUP MENU
RNGE PASS CLK MORE
RANGE CONTROL MENU
UNIT
RANGE MODE:SNGL
ENTR
RANGE CONTROL MENU
UNIT
RANGE: 500.0 Conc
5 0 0 .0 ENTR
RANGE CONTROL MENU
UNIT
CONC UNITS:PPM
ENTR
Reporting Range Verification
SETUP
EXIT
EXIT
EXIT
EXIT
EXIT
Press EXIT
3x's to return
the unit to the
EXIT
SAMPLE mode
EXIT
06807F DCN7335
Analyzer
2