Remote Das Configuration Via Apicom; Figure 7-14: Sample Apicom User Interface For Configuring The Das - Teledyne t100 Operation Manual

Data Acquisition System (DAS) and APICOM
7.4.

REMOTE DAS CONFIGURATION VIA APICOM

166
Editing channels, parameters and triggering events as described in this section is
performed via the APICOM remote control program using the graphic interface similar
to the example shown in Figure 7-14. Refer to Section 8 for details on remote access to
the T100 analyzer.
Figure 7-14: Sample APICOM User Interface for Configuring the DAS
Once a DAS configuration is edited (which can be done offline and without interrupting
DAS data collection), it is conveniently uploaded to the instrument and can be stored on
a computer for later review, alteration or documentation and archival. Refer to the
APICOM manual for details on these procedures. The APICOM user manual (Teledyne
API's P/N 039450000) is included in the APICOM installation file, which can be
downloaded at http://www.teledyne-api.com/software/apicom/.
Although Teledyne API recommends the use of APICOM, the DAS can also be
accessed and configured through a terminal emulation program such as HyperTerminal
(refer to Figure 7-15). However, all configuration commands must be created following
a strict syntax or be pasted in from of a text file, which was edited offline and then
uploaded through a specific transfer procedure.
Teledyne API - T100 UV Fluorescence SO Analyzer
2
06807F DCN7335