Setup - Comm: Communications Ports; Id (Instrument Identification); Figure 5-13: Setup - Comm Menu - Teledyne t100 Operation Manual

SETUP Menu
5.7. SETUP – COMM: COMMUNICATIONS PORTS
If the default password 818
is replaced by 000, then
Password Protection has
been enabled. Refer to
SETUP: PASS.
5.7.1.

ID (INSTRUMENT IDENTIFICATION)

98
This section introduces the communications setup menu; Section 6 provides the setup
instructions and operation information. Press SETUP>ENTR>MORE>COMM to arrive
at the communications menu.
SAMPLE
< TST TST > CAL
SAMPLE
SETUP X.X
CFG DAS RNGE PASS CLK
SETUP X.X
COMM
SETUP X.X
Figure 5-13:
In the SETUP>MORE>COMM menu press ID to display and/or change the Machine
ID, which must be changed to a unique identifier (number) when more than one
instrument of the same model is used in a multidrop configuration (Section 3.3.1.8) or
when applying MODBUS protocol (Section 6.6.1). The default ID is typically the same
as the model number; for the Model T100, the ID is 0100 (but could be 0000). Press any
button(s) in the MACHINE ID menu (Figure 5-14) until the Machine ID Parameter field
displays the desired identifier.
Teledyne API - T100 UV Fluorescence SO
RANGE = 500.000 PPB
ENTER SETUP PASS : 818
8 1 8
PRIMARY SETUP MENU
SECONDARY SETUP MENU
VARS DIAG
COMMUNICATIONS MENU
ID INET COM1 COM2
SETUP – COMM Menu
SO2 =XXX.X
SETUP
ENTR EXIT
MORE EXIT
EXIT
EXIT
06807F DCN7335
Analyzer
2