Instrument Maintenance - Teledyne t100 Operation Manual

10.

INSTRUMENT MAINTENANCE

Note:
I
MPORTANT
Note
06807F DCN7335
Predictive diagnostic functions including data acquisition, failure warnings and alarms
built into the analyzer allow the user to determine when repairs are necessary. However,
preventive maintenance procedures that, when performed regularly, will help to ensure
that the analyzer continues to operate accurately and reliably over its lifetime.
Maintenance procedures are covered in this section, followed by troubleshooting and
service procedures in Section 11 of this manual.
To support your understanding of the technical details of maintenance,
Section 12, Principles of Operation, provides information about how the
instrument works.
A span and zero calibration check must be performed following some of
the maintenance procedures listed below. Refer to Section 9.
WARNING! RISK OF ELECTRICAL SHOCK
Disconnect power before performing any operations that require entry
into the interior of the analyzer, unless running the analyzer is necessary
for a specific procedure.
All maintenance and service procedures must be performed only by a
qualified technician.
The front panel of the analyzer is hinged at the bottom and may be
opened by two fasteners located in the upper right and left corners to
gain access to various components that are either mounted on the panel
itself or located near the front of the instrument (such as the particulate
filter).
I R
MPACT ON EADINGS OR
D
ATA
207