Figure 5-5: Setup Rnge - Dual Range Mode - Teledyne t100 Operation Manual

SETUP Menu
5.4.3.2. DUAL RANGE MODE (DUAL)
SAMPLE RANGE = 500.000 PPB
< TST TST > CAL
SAMPLE ENTER SETUP PASS : 818
8 1 8
PRIMARY SETUP MENU
SETUP X.X
CFG DAS RNGE PASS CLK MORE
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT
SETUP X.X RANGE MODE:
SNGL DUAL AUTO
.
I
MPORTANT
88
Selecting Dual Range mode allows the A1 and A2 outputs to be configured with
different reporting ranges. The analyzer software calls these two ranges low and high.
The Low range setting corresponds with the analog output labeled A1 on the rear panel
of the instrument. The high range setting corresponds with the A2 output. While the
software names these two ranges low and high, they do not have to be configured that
way. For example: the low range can be set for a span of 0-150 ppb while the high range
is set for 0-50 ppb.
In DUAL range mode the RANGE test function displayed on the front panel will be
replaced by two separate functions:
•
RANGE1: The range setting for the A1 output.
•
RANGE2: The range setting for the A2 output.
To set the ranges, press the following control button sequence:
SO2 =XXX.X
SETUP
ENTR EXIT
EXIT
EXIT
SNGL
ENTR EXIT
Figure 5-5: SETUP RNGE – Dual Range Mode
In DUAL range mode the LOW and HIGH ranges have separate slopes
and offsets for computing SO
independently calibrated.
Teledyne API - T100 UV Fluorescence SO
SETUP X.X RANGE MODE: DUAL
SNGL DUAL AUTO
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT
SETUP X.X LOW RANGE: 500.0 Conc
0 0 1 0 0 .0
SETUP X.X HIGH RANGE: 500.0 Conc
0 0 5 0 0
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT
I R
MPACT ON EADINGS OR
concentration. The two ranges must be
2
ENTR EXIT
EXIT
Toggle the
ENTR EXIT
numeral buttons
to set the upper
limit of each
range.
.0 ENTR EXIT
EXIT SAMPLE Display
D
ATA
06807F DCN7335
Analyzer
2
EXIT Returns
to the Main