The "Layer 3 (Ipv4)" Menu; Configuration - Siemens SCALANCE XM-400 Configuration Manual

5.6

The "Layer 3 (IPv4)" menu

5.6.1

Configuration

Introduction
The page contains the overview of the layer 3 functions for IPv4 of the device. On this page,
you enable or disable the required layer 3 function.
Die functions "Routing", "VRRP", "OSPF", "RIP" and "PIM" are available only on layer 3.
Description of the displayed boxes
The page contains the following boxes:
● Routing (only available with devices with a layer 3 license)
– Enabled
– Disabled
● DHCP Relay Agent
Enable or disable the DHCP relay agent. You can configure other settings in "Layer 3
(IPv4)> DHCP Relay Agent".
● VRRP (only available with devices with a layer 3 license)
Enable or disable routing using VRRP. To use VRRP, first enable the routing function. You
can configure other settings in "Layer 3 (IPv4) > VRRP".
● OSPF (only available with devices with a layer 3 license)
Enable or disable routing using OSPF. To use OSPF, first enable the "Routing" function.
You can configure other settings in "Layer 3 (IPv4) > OSPF".
SCALANCE XM-400/XR-500 Web Based Management (WBM)
Configuration Manual, 05/2017, C79000-G8976-C248-12
IPv4 routing is enabled. You can only enable the routing function if DHCP is disabled
on all configured interfaces.
IPv4 routing is disabled. If IPv6 routing is enabled, this is also disabled.
Configuring with Web Based Management
5.6 The "Layer 3 (IPv4)" menu
339