Siemens SCALANCE XM-400 Configuration Manual page 81
Industrial ethernet switches
Hide thumbs
Also See for SCALANCE XM-400:
- Configuration manual (960 pages) ,
- Operating instructions manual (80 pages) ,
- Instructions manual (60 pages)
Table of Contents
Advertisement
Content area (4)
The content area shows a graphic of the device. The graphic is dynamic. The basic device is
always shown. If extenders/media modules are connected to the basic device, these are also
shown.
Figure 5-1
Example of a device graphic: SCALANCE XM416-4C with one port extender PE408
The following is displayed below the device graphic:
● PROFINET Name of Station
● System Name
Shows the name of the device.
● Device Type
Shows the type designation of the device.
● PROFINET AR Status
Shows the PROFINET IO application relation status.
– Online
– Offline
● Power Supply 1 / Power Supply 2
– Up
– Down
SCALANCE XM-400/XR-500 Web Based Management (WBM)
Configuration Manual, 05/2017, C79000-G8976-C248-12
Shows the PROFINET device name.
There is a connection to a PROFINET controller. The PROFINET controller has
downloaded its configuration data to the device. The device can send status data to the
PROFINET controller.
In this status, the parameters set via the PROFINET controller cannot be configured on
the device.
There is no connection to a PROFINET controller.
Power supply 1 or 2 is applied.
Power supply 1 or 2 is not applied or is below the permitted voltage.
Configuring with Web Based Management
5.3 The "Information" menu
81
Advertisement
Table of Contents
