Configuring with Web Based Management
5.6 The "Layer 3 (IPv4)" menu
Description
The page contains the following:
● Interface / VRID
Select the ID of the virtual router.
● Associated IP Address
Enter the IPv4 address that the virtual router will monitor.
A maximum of 10 IPv4 addresses are possible.
The table has the following columns:
● Select
Select the check box in the row to be deleted
● Associated IP Address
Shows the IPv4 addresses that the virtual router monitors.
Steps in configuration
1. Select the ID of the virtual router.
2. Enter the IPv4 address that the virtual router will monitor.
3. Click the "Create" button. A new entry is generated in the table.
5.6.8.5
Interface Tracking
Introduction
On this page, you configure the monitoring of interfaces.
When the link of a monitored interface changes from "up" to "down", the priority of the assigned
VRRP interface is reduced. You configure the value by which the priority is reduced on the
page "Layer 3 > VRRP/VRRPv3 > Configuration".
378
SCALANCE XM-400/XR-500 Web Based Management (WBM)
Configuration Manual, 05/2017, C79000-G8976-C248-12