Subnets; Overview - Siemens SCALANCE XM-400 Configuration Manual
Industrial ethernet switches
Hide thumbs
Also See for SCALANCE XM-400:
- Configuration manual (960 pages) ,
- Operating instructions manual (80 pages) ,
- Instructions manual (60 pages)
Table of Contents
Advertisement
Configuring with Web Based Management
5.6 The "Layer 3 (IPv4)" menu
● RIP (only available with devices with a layer 3 license)
Enable or disable routing using RIP. To use RIP , first enable the routing function. You can
configure other settings in "Layer 3 (IPv4) > RIP".
● PIM Routing (only available with devices with a layer 3 license)
Enable or disable the PIM routing. You can configure other settings in "Layer 3 (IPv4) >
PIM".
Steps in configuration
1. To use the required function, select the corresponding check box.
2. Click the "Set Values" button.
5.6.2
Subnets
5.6.2.1
Overview
Creating subnets
The page shows the subnets for the selected interface. If more than one subnet is available
on an interface, the first entry of this interface is of the address type "Primary".
All other subnets are created on this page. A subnet always relates to an interface. The
interface is created on the "Configuration" tab.
Description of the displayed values
The page contains the following boxes:
● Interface
Select the interface on which you want to configure another subnet.
340
SCALANCE XM-400/XR-500 Web Based Management (WBM)
Configuration Manual, 05/2017, C79000-G8976-C248-12
Advertisement
Table of Contents
