Mac Flow - Siemens SCALANCE XM-400 Configuration Manual

The table "Ingress Mirroring " has the following columns:
● Select
Select the row you want to delete.
● VLAN ID
Shows the VLAN ID for which the incoming frames are mirrored. The VLAN ID (a number
between 1 and 4094) can only be assigned once when creating a new data record and can
then no longer be changed. To make a change, the entire data record must be deleted and
created again.
5.5.7.4

MAC Flow

ACL filter for port mirroring
You can only configure the settings on this page if you have already generated a session ID
with the session type " "MAC ACL" on the "General" tab.
The ACL filter decides which data is available at the monitor port.
Description of the displayed boxes
● Session ID
Select the session you want to monitor. Only one session is possible.
● ACL Filter Number
Shows the number of the ACL filter.
● Ingress Mirroring
Shows whether incoming packets are mirrored.
Note
Rules
The selected rule only becomes active when you specify with which ACL rules the incoming
packets will be filtered for at least one interface. You configure the settings in "Security >
MAC ACL > Ingress Rules".
● Source MAC
Shows the MAC address of the sender.
SCALANCE XM-400/XR-500 Web Based Management (WBM)
Configuration Manual, 05/2017, C79000-G8976-C248-12
Configuring with Web Based Management
5.5 The "Layer 2" menu
281