Siemens SCALANCE XM-400 Configuration Manual page 362

Configuring with Web Based Management
5.6 The "Layer 3 (IPv4)" menu
● Circuit ID Receive Port
Enable or disable the check box. If you enable the check box, the receiving port is added
to the generated circuit ID.
Note
You need to select a least one option.
You will find further information on the router index (Circuit ID Router Index) and port index
(Circuit ID Receive Port) in the IfTable using SNMP.
You will find the VLAN ID on the WBM page "Layer 2 > VLAN > General".
● Remote ID
Shows the device ID.
Interface-specific configuration
● Interface
Select the interface from the drop-down list.
The table has the following columns:
● Select
Select the row you want to delete.
● Interface
Shows the interface.
Note
If you have not created an interface-specific configuration, the global configuration with the
MAC address is used as the device ID.
● Remote ID Type
Select the type of device ID from the drop-down list. You have the following options:
– IP Address
– MAC Address
– Free Text
● Remote ID
Enter the device name. The box can only be edited if you select the entry "Free Text" for
"Remote ID Type".
362
The IPv4 address of the device is used as the device ID.
The MAC address of the device is used as the device ID.
If you use "Free Text", you can enter the device name as the device identifier in "Remote
ID".
SCALANCE XM-400/XR-500 Web Based Management (WBM)
Configuration Manual, 05/2017, C79000-G8976-C248-12