Siemens SCALANCE XM-400 Configuration Manual page 381
Industrial ethernet switches
Hide thumbs
Also See for SCALANCE XM-400:
- Configuration manual (960 pages) ,
- Operating instructions manual (80 pages) ,
- Instructions manual (60 pages)
Table of Contents
Advertisement
Description of the displayed values
The page contains the following boxes
● OSPFv2
Enable or disable routing using OSPFv2.
● Router ID
Enter the name of one of the OSPFv2 interfaces. The name is entered in the IP address
format and does not need to match the local IP address. The router ID must be unique in
the network.
● OSPFv2-RFC1583 Compatibility
Enable the option if you still have old OSPFv2 routers in operation that are not compatible
with RFC 2328.
● Border Router
Shows the status of the OSPFv2 router. If the local system is an active member in at least
2 areas, this is an area border router.
● AS Border Router
Specify whether the router is an AS border router. An AS border router intercedes between
multiple autonomous systems, for example if you have an additional RIP network. An AS
border router is also necessary to add and to distribute static routes.
● New LSA Received
Shows the number of received LSAs.
Updates and local LSAs are not counted.
● New LSA Configured
Shows the number of different LSAs sent by this local system.
● External LSA Maximum
To limit the number of entries of external LSAs in the database, enter the maximum number
of external LSAs.
● Exit Interval [s]
Enter the interval after which the OSPFv2 router once again attempts to come out of the
overflow status. A 0 means that the OSPF router attempts to exit the overflow status only
following a restart.
● Inbound Filter
Select a route map that filters inbound routes.
● Redistribute Routes (Default/Connected/Static)
Specify which known routes are distributed using OSPFv2. You can make different
decisions for the route types Default, Connected and Static.
Note
The options can only be enabled on an AS border router. Enabling the Default and Static
options, in particular, can cause problems if they are enabled at too many points in the
network, for example, forwarding loops.
● Route Map
Select a route map that filters which routes are forwarded using RIPv2.
SCALANCE XM-400/XR-500 Web Based Management (WBM)
Configuration Manual, 05/2017, C79000-G8976-C248-12
Configuring with Web Based Management
5.6 The "Layer 3 (IPv4)" menu
381
Advertisement
Table of Contents
