Siemens SCALANCE XM-400 Configuration Manual page 277

● Session Type
Select the required entry from the drop-down list:
– -
– Port Based
– VLAN
– MAC ACL
– IP ACL
Note
If you have created a session of the type "VLAN" "MAC ACL" or "IP ACL", you cannot create
any further sessions. You can create up to 7 sessions of the type "Port-based".
Note
If you change the "Session Type" of an existing session, all previous configurations of this
session are lost.
● Status
Shows whether or not mirroring is enabled.
● Hardware Index
If in a VLAN you select more than one source port for the port-based egress mirroring,
unknown unicast and multicast frames as well as broadcast frames are forwarded only
once to the destination port. With several sessions, the corresponding frames are only
visible in one session. They are only mirrored on the destination port with the lowest
hardware index.
● Dest. Port
From the drop-down list, select the destination port to which data will be mirrored in this
session.
Note
Function Extender BUS ANALYZER Agent XM-400
If you connect a function extender BUS ANALYZER Agent XM-400 with a SCALANCE
XM-400 basic device, you can select up to four ports of the function extender BUS
ANALYZER Agent XM-400 as destination ports. Function extender BUS ANALYZER Agent
XM-400 supports port-based, VLAN-based, MAC ACL-based and IP ACL-based mirroring.
● RSPAN
Enable or disable RSPAN for a session.
SCALANCE XM-400/XR-500 Web Based Management (WBM)
Configuration Manual, 05/2017, C79000-G8976-C248-12
None
Port-based mirroring
VLAN-based mirroring
Mirroring of the MAC Access Control List
Mirroring of the IP Access Control List
Configuring with Web Based Management
5.5 The "Layer 2" menu
277