Interfaces - Siemens SCALANCE XM-400 Configuration Manual

Description
The page contains the following boxes:
● Area ID
Select the area ID of the area. You specify the ID on the "Areas" tab.
● Prefix
Enter the IPv6 address of the network that will be grouped.
● Prefix Length
Enter the number of bits belonging to the prefix that will be grouped.
This table contains the following columns:
● Select
Select the check box in the row to be deleted.
● Area ID
Shows the ID of the area.
● Prefix
Shows the IPv6 address of the network that will be grouped.
● Prefix Length
Enter the number of bits that will belong to the prefix.
● Advertise
Enable this option to advertise the grouped network.
Steps in configuration
1. Select the area ID of the area.
2. Enter the prefix of the network that will be grouped.
3. Enter the prefix length of the network that will be grouped.
4. Click the "Create" button. A new entry is generated in the table.
5. Enable the "Advertise" option to advertise the grouped network.
6. Click the "Set Values" button.
5.7.8.4

Interfaces

Overview
On this page, you can configure OSPFv3 interfaces.
Note
This function is available only with layer 3.
SCALANCE XM-400/XR-500 Web Based Management (WBM)
Configuration Manual, 05/2017, C79000-G8976-C248-12
Configuring with Web Based Management
5.7 The "Layer 3 (IPv6)" menu
435