Connecting A Fiber-Optic Cable To The Ptx1000 - Juniper PTX1000 Hardware Manual

To disconnect a fiber-optic cable from an optical transceiver installed in the PTX1000:
1. (Recommended) Disable the port in which the transceiver is installed by including the disable statement
at the [edit interfaces] hierarchy level for the specific interface:
[edit interfaces]
set interface-name disable
WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceivers emit laser light that can damage your eyes.
WARNING:
instruments even if the interface has been disabled.
2. Carefully unplug the fiber-optic cable connector from the transceiver.
3. Cover the transceiver with a rubber safety cap.
WARNING:
or removing a cable. The rubber safety cap keeps the port clean and prevents
accidental exposure to laser light.
4. Cover the fiber-optic cable connector with the rubber safety cap.

Connecting a Fiber-Optic Cable to the PTX1000

The PTX1000 has optical transceivers to which you can connect fiber-optic cables.
Before you connect a fiber-optic cable to a PTX1000, ensure that you have taken the necessary precautions
for safe handling of lasers (see
LED Safety Guidelines and Warnings" on page
Do not look directly into a fiber-optic transceiver or into the ends of
Do not stare into the laser beam or view it directly with optical
Do not leave a fiber-optic transceiver uncovered except when inserting
"Radiation from Open Port Apertures Warning" on page 148
149).
109
and "Laser and