EFI Driver Setting Items
An EFI driver setting items necessary in order to build LPAR manager are
below.
Item
Boot Function
Connection Type Sets the connection form of FC-interface.
Data Rate
Select Boot
Device
LUID scan mode Sets LUID scan mode to "Disabled". (Note that
Boot Device List
B-8
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Table B-2 EFI Driver setting items
Setting Items Description
Sets Enabled when San-Boot-function enables.
It is necessary to set Enabled to a FC port of
Boot path.
Sets the Data transfer speed of FC-interface.
Sets Enable when searching Boot-Device that is
registered to Boot-Device-list.
the LUID inheritance method is not supported.)
If LUID scan mode is not displayed, you do not
need to set LUID scan mode.
Registers the using Boot Device when select
Boot Device is set Enabled.
Setting Item List
default
Disabled
Auto
Depends on a
factory-shipments
state
Disabled
Disabled
(All Zero)