List Of Snmp Traps - Hirschmann RS20 User Manual

Operation Diagnosis
9.1.1

List of SNMP traps

The following table shows a list of the traps that can be sent by the device.
Trap name
authenticationFailure
coldStart
hmAutoconfigAdapterTrap this is sent when the AutoConfiguration AdapterACA is
linkDown
linkUp
hmTemperature
hmPowerSupply
hmSigConRelayChange
newRoot
topologyChange
risingAlarm
fallingAlarm
hmPortSecurityTrap
hmModuleMapChange
hmBPDUGuardTrap
hmMrpReconfig
hmRingRedReconfig
hmRingRedCplReconfig
hmSNTPTrap
hmRelayDuplicateTrap
lldpRemTablesChangeTra
p
hmConfigurationSavedTra
p
hmConfigurationChangedT
rap
Table 18: Possible traps
UM BasicConfig L2E
Release 8.0 05/2013
Meaning
this is sent if a station attempts to access an agent without
authorisation.
this is sent during the boot phase for both cold starts and warm
starts, after successful initialisation of the network management.
disconnected or connected.
this is sent if the connection to a port is interrupted.
this is sent when connection is established to a port.
this is sent if the temperature exceeds the set threshold limits.
this is sent if the power supply status changes.
this is sent if the status of the signal contact changes in the
function monitoring.
this is sent if the sending agent becomes the new root of the
spanning tree.
this is sent if the switching mode of a port changes.
this is sent if an RMON alarm input exceeds its upper threshold.
this is sent if an RMON alarm input goes below its lower threshold.
this is sent if an MAC/IP address detected on this port does not
correspond to the current settings for
– hmPortSecPermission and
– hmPorSecAction is set to either trapOnly (2) or portDisable (3).
this is sent if the hardware configuration changes.
this is sent if a BPDU is received on a port while the BPDU Guard
function is active.
this is sent if the configuration of the MRP Ring changes.
this is sent if the configuration of the HIPER Ring changes.
this is sent if the configuration of the redundant ring/network
coupling changes.
this is sent if an error occurs in relation to the SNTP (e.g. server
not available).
this is sent if a duplicate IP address is detected in relation to DHCP
Option 82.
this is sent if an entry in the Remote Table topology changes.
this is sent after the device has successfully saved its
configuration locally.
this is sent if you change the configuration of the device after
saving locally for the first time.
9.1 Sending Traps
159