Device Status; Configuring Traps - Hirschmann Power MICE Reference Manual

Diagnostics

9.6.3 Device status

Select the tab page "Alarm 1" or "Alarm 2" (for devices with two signal
contacts).
In the "Mode Signal Contact" field, you select the "Device status" mode.
In this mode, the signal contact is used to monitor the status of the device
(see on page 193 „Device Status")
possible.
The device status "Error"
by means of a break in the contact via the potential-free signal contact
(relay contact, closed circuit).

9.6.4 Configuring traps

Select generate Trap, if the device is to create a trap as soon as the
position of a signal contact changes when function monitoring is active.
Figure 80: Signal contact dialog
RM Web L3P
Release 4.1 03/08
and thereby makes remote diagnosis
(see on page 193 „Device Status")
9.6 Signal contact
is reported
197