Snmp-Server Enable Traps Linkmode - Hirschmann RS20 Reference Manual

CLI Commands: Base

4.3.29 snmp-server enable traps linkmode

This command enables Link Up/Down traps for the entire switch. When en-
abled, link traps are sent only if the Link Trap flag setting associated with the
port is enabled (see 'snmp trap link-status' command).
Default
enabled
Format
snmp-server enable traps linkmode
Mode
Global Config
no snmp-server enable traps linkmode
U
This command disables Link Up/Down traps for the entire switch.
Format
no snmp-server enable traps linkmode
Mode
Global Config
CLI L2B
Release 4.0 11/07
4.3 Management Commands
87