Turn Signal Relay; Side Stand Switch; Performance Test - Honda 1998 VT750C Service Manual

7 -
I
TURN SIGNAL RELAY
REMOVAL/INSTALLATION
Remove the headlight (page 19-7).
Disconnect the turn signal relay 3P connector.
Remove the turn signal relay.
Installation is in the reverse order of removal.
PERFORMANCE TEST
Check the turn signal circuit connection before testing.
Short the Black and Gray terminals of the turn signal
relay connector with a jumper wire. Turn the ignition
switch ON and check the turn signal light by turning
the turn signal switch ON.
If the light does not come on, check the turn signal
switch for an open circuit in Black or Gray wire.
If the light comes on, check for continuity between
Green terminal and body ground at the turn signal
relay 3P (Black) connector.
- No continuity: Open circuit in Green wire
- Continuity: • Loose or poor contact of the turn
signal relay 3P connector
• Faulty turn signal relay
SIDE STAND SWITCH
INSPECTION
Remove the right side cover (page 2-4).
Disconnect the side stand switch 3P (Green)
connector.
Check for continuity between each of the terminals
as below.
There should be continuity between the
0-0
positions on the chart below.
SIDE STAND SWITCH
--------
G/W
Y/BI G
Side stand
down
Side stand
up
LIGHTS/METERS/SWITCHES
0 0
3P CONNECTOR
19-23