6.14 Tool—UT Option Setting
Option settings can be specified for KX-UT series SIP phones on a system-wide level.
Note
The following apply when programming in On-line mode only:
•
To set these parameters, all installed V-UTEXT cards must first be set to OUS. For details, see 9.1 PBX
Configuration—[1-1] Configuration—Slot.
Numbering Plan for UT Series Terminal
One or more number dialling plans can be specified for KX-UT series SIP phones. Enter the dial plan text string
into the text box, and then click OK. A dial plan text string may also be copied and pasted into the text box
from another source.
Note
•
For more information about dial plans, refer to the Administrator Guide of the relevant KX-UT series
SIP phone.
•
You can enter up to 500 characters in the dial plan text box.
•
You can assign up to 20 dial plans, separating them with a "|" (vertical bar).
•
You can assign up to 32 digits per dial plan.
•
When OK is clicked, the entered text string will be validated. If there is a validation error, a message
will be displayed.
Timer for UT Series Terminal
This timer specifies for KX-UT series SIP phones how long the system waits for another digit to be dialled
before determining that dialling has finished. This value will apply for all KX-UT series SIP phones connected
to the PBX. Specify a number of seconds in Extension Inter-digit (s), and then click OK.
If the value for the timer is changed, the new value will be applied to each KX-UT series SIP phone after it is
restarted.
6.14 Tool—UT Option Setting
PC Programming Manual
99