Panasonic kx-ns500 Pc Programming Manual page 814

23.3.5 UM Configuration—[4-3] Service Settings—Custom Service—Password
Feature Guide References
3.2.1.15 Custom Service
No DTMF Input Operation
Determines how calls are handled when callers do not dial any numbers in response to system guidance (often
because they are rotary telephone users). The default setting is "Operator", which allows the caller to be
automatically connected to an operator after the message is played.
Value Range
Trf to Mbx, Trf to Ext, Operator, Trf to Out, Exit, Prev Menu, CS (see 23.3.1 UM Configuration—[4-3] Service
Settings—Custom Service—Menu & Transfer—
Feature Guide References
3.2.1.15 Custom Service
Entry Failure
Determines what operation is activated when a caller enters an invalid password X times. (X= the value set
for Maximum Number of Invalid Entry (1-10))
Value Range
Trf to Mbx, Trf to Ext, Operator, Trf to Out, Exit, Prev Menu, CS, VM Serv, Call Trf Serv, Subscriber Serv, Dial
by Name, Repeat Menu, Main Menu, Trf to Fax Extn, List All Names (see 23.3.1 UM Configuration—[4-3]
Service Settings—Custom Service—Menu & Transfer—
Feature Guide References
3.2.1.15 Custom Service
Pass1–5, Cancel
Pass1–5:
Specifies a password and an operation for the specified password.
Cancel:
Determines the operation that is activated when a caller presses "#" to cancel password entry.
Value Range
Pass1–5:
Password: Max. 12 digits
Assigned Operation: Trf to Mbx, Trf to Ext, Operator, Trf to Out, Exit, Prev Menu, CS, VM Serv, Call Trf Serv,
Subscriber Serv, Dial by Name, Repeat Menu, Main Menu, Trf to Fax Extn, List All Names, None (see
23.3.1 UM Configuration—[4-3] Service Settings—Custom Service—Menu & Transfer—
Assigned Operation: 0–9, *, #)
Cancel:
Assigned Operation: Trf to Mbx, Trf to Ext, Operator, Trf to Out, Exit, Prev Menu, CS, VM Serv, Call Trf Serv,
Subscriber Serv, Dial by Name, Repeat Menu, Main Menu, Trf to Fax Extn, List All Names, None (see
23.3.1 UM Configuration—[4-3] Service Settings—Custom Service—Menu & Transfer—
Assigned Operation: 0–9, *, #)
814 PC Programming Manual
No DTMF Input Operation)
Key – Assigned Operation: 0–9, *, #)
Key –
Key –