Setting Vlan Parameters - Panasonic KX-NS300 Installation Manual

5.7.2 Setting VLAN Parameters

To establish voice communications between IP telephones, the primary ports of the IP telephones and the
connected PBX must belong to the same VLAN. Consult your network administrator and obtain the appropriate
VLAN ID.
If you are using an IP telephone equipped with two ports, it is possible to place primary and secondary ports
of the IP telephone on different VLANs by assigning separate VLAN IDs to each port.
Follow the procedure below for all IP-PTs on the network, using appropriate VLAN IDs.
Note
The procedure for SIP phones may vary depending on the type of the SIP phone being used. Refer to the
documentation of your SIP phone for instructions.
KX-NT300 series (except KX-NT321) and KX-NT500 series (except KX-NT511 and KX-NT551)
After assigning
the IP addresses
To set the VLAN ID for the primary port
Select "Primary port".
ENTER
To set the VLAN ID for the secondary port
Return to the
VLAN setting screen.
VLAN ID
1–4094
0-4094 (Only for KX-NT55x)
To end programming
Return to the
Menu screen.
*1 The VLAN priority of the primary port must be set higher than the priority of the secondary port. The larger the number, the higher
the priority.
Select "QoS". ENTER
ENTER
Select "VLAN Priority". ENTER
Select
"Secondary port (TO PC)".
ENTER Select
"VLAN Priority".
STORE
Press "STORE".
Select "VLAN".
Select "VLAN ID". ENTER
VLAN Priority
0–7
ENTER Select "VLAN ID".
ENTER
The IP-PT will reboot
and can then be
registered to the PBX.
5.7.2 Setting VLAN Parameters
ENTER Select "Enable" for
VLAN setting.
VLAN ID
1–4094
0-4094 (Only for KX-NT55x)
*1
ENTER
ENTER
*1
VLAN Priority 1
0–7 ENTER
Installation Manual 199